Unzip and install Perceptron Scanworks from cimcoreV45B87.zip.
the password is: 
6GWMJX

FOR THE FIRST RUN:
- Run SA (v. 2005.11.03 or later) and the CimCore arm interface once, and close it.
  This will automatically set a registry key used by ScanWorks.
- Make sure the arm is connected, with the scanner connected and powered up.
- Run ScanWorks, and make sure 'OUtput data to TCP/IP' is checked.
- Minimize ScanWorks.
- Run the arm interface again, and use the arm/scanner as desired 
  (see 'Using the Perceptron Contour Scanner with SA.pdf').

From this point on, you can run ScanWorks and minimize it, then run the SA arm interface.
(Always make sure the scanner is connected and powered on before starting ScanWorks.)  
You'll then be able to switch in and out of scan mode by switching probes on the arm, and 
selecting the desired measure mode.